100 and 110 Degree Remixes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Because people seem to have trouble with the parent bracket causing too tight an angle, I loosened the angle..
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 25
- Makes
- 0
- Views
- 298
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I'll leave this up here, but I now believe this other remix is a better solution to this issue.. I would try this instead: https://www.printables.com/model/338542-x1-ptfe-tube-guide-to-fix-loading-issues-best-of-b
This takes the parent design, but loosens the angle to either 100 or 110 degrees, to give slightly different fits, which ought to cause less of a binding issue for some people who found the parent too tight a bend. Note that this may cause your PTFE tube to hit up against the glass, however, depending on the length of your tube.
I printed these flat side down with a little bit of painted on support, as shown in the pic.