Under hood light push pin for 87-93 Foxbody Mustang
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slide-in pushpin for the under-hood light, the light has one pin built in then this one which slides in and locks.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 25
- Makes
- 0
- Views
- 421
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Public Domain
Designed this to replace a missing part on my mustang, CAD file is available should you need to tweak, the push pin fins came out fairly ugly but do the job. If anyone knows how to make them more printable please feel free to modify and re-release.
Supports: On build plate. I removed my supports by cutting under the 2 side tabs with a razor blade then laying the part down on its back and cutting from the tip of the pushpin towards the body.

Material: Print this in the highest temp material you can, PETG might last since it's not holding much weight but a lot of heat is directed to the underside of the hood. I printed mine in PETG to test through winter (starting December 13 2022) and will update if/when it fails. ABS/ASA would be a better choice.
Installation: Slide the push pin in from the connector side and push until the tab clicks over the retainer (photo reference below). I had to use a flathead to push it in fully, it should take little effort with a tool. I then pushed back from the opposite direction to ensure that it was locked in securely.
