1 / 3
Hypario 508 X-Soft Antenna Cover Retaining Sleeve — image 1
1 / 3

Hypario 508 X-Soft Antenna Cover Retaining Sleeve

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has…

Rating
0 / 5
Likes
2
Downloads
19
Makes
0
Views
398
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has one minor problem: the soft rubber covering on the antenna can come loose under extreme conditions (like inside your pocket while snowboarding ;) exposing the active element to possible damage and loosing the cover.

This sleeve, when slipped over the base of the cover stays in place by compression friction of the soft rubber cover and keeps it intact without adhesives.

Enjoy !

-=dave

Link to Hyperio 508 attenna: http://amzn.com/B00KBS0T02

Customized version of http://www.thingiverse.com/thing:812337

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing\_id=812337

Print instructions

Category: Electronics Summary

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has one minor problem: the soft rubber covering on the antenna can come loose under extreme conditions (like inside your pocket while snowboarding ;) exposing the active element to possible damage and loosing the cover.

This sleeve, when slipped over the base of the cover stays in place by compression friction of the soft rubber cover and keeps it intact without adhesives.

Enjoy !

-=dave

Link to Hyperio 508 attenna: http://amzn.com/B00KBS0T02

Customized version of http://www.thingiverse.com/thing:812337

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing\_id=812337

Print Settings

Printer Brand: Printrbot

Printer: Simple White

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: 200 microns

Infill: 100%

Notes:

You can spiralize this if you want to prevent a Z-scar, since it should be a single nozzle width for any 0.4mm nozzle printer.

Instructions

Using the following options:

$fn = 200
outerBottomDiameter = 16
innerConnicVariation = 0
outerConnicVariation = 0
height = 15
innerBottomDiameter = 15

Tags