1 / 3
Hypario 508 X-Soft Antenna Cover Retaining Sleeve — zdjęcie 1
1 / 3

Hypario 508 X-Soft Antenna Cover Retaining Sleeve

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has…

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
398
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has one minor problem: the soft rubber covering on the antenna can come loose under extreme conditions (like inside your pocket while snowboarding ;) exposing the active element to possible damage and loosing the cover.

This sleeve, when slipped over the base of the cover stays in place by compression friction of the soft rubber cover and keeps it intact without adhesives.

Enjoy !

-=dave

Link to Hyperio 508 attenna: http://amzn.com/B00KBS0T02

Customized version of http://www.thingiverse.com/thing:812337

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing\_id=812337

Print instructions

Category: Electronics Summary

The very reasonably priced and good-perhforming Hypario 508 X-Soft dual-band 144/430MHz HF/UHF Mini SMA-F antenna has one minor problem: the soft rubber covering on the antenna can come loose under extreme conditions (like inside your pocket while snowboarding ;) exposing the active element to possible damage and loosing the cover.

This sleeve, when slipped over the base of the cover stays in place by compression friction of the soft rubber cover and keeps it intact without adhesives.

Enjoy !

-=dave

Link to Hyperio 508 attenna: http://amzn.com/B00KBS0T02

Customized version of http://www.thingiverse.com/thing:812337

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing\_id=812337

Print Settings

Printer Brand: Printrbot

Printer: Simple White

Rafts: Doesn't Matter

Supports: Doesn't Matter

Resolution: 200 microns

Infill: 100%

Notes:

You can spiralize this if you want to prevent a Z-scar, since it should be a single nozzle width for any 0.4mm nozzle printer.

Instructions

Using the following options:

$fn = 200
outerBottomDiameter = 16
innerConnicVariation = 0
outerConnicVariation = 0
height = 15
innerBottomDiameter = 15

Tagi