Toyota Key Fob Enclosure (3 Button)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.82 – €1.00 net (excluding VAT)
For file: Key Set_0.2mm_PETG_MK3S_57m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.91 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 57.6 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a remix of xdcmx's key fob enclosure to accommodate the panic button on the back of the Toyota key fobs.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 643
- Makes
- 1
- Views
- 4,313
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of xdcmx's key fob enclosure to accommodate the panic button on the back of the Toyota key fobs. Prints flat without supports. This should replace the plastic enclosure on TOY44 and TOYMT40 key fobs.
I broke the plastic enclosure on my key fob for my old(er) Toyota. I liked xdcmx's design, but I wanted to retain the functionality of having the panic button on the back of the key fob. I measured out the size and location of the button and made a new model of the original design that will leave an empty space where the panic button can be accessed.
Assembly is somewhat complicated. You will need to remove the red rubber panic button covering from your original key fob, and remove any hard plastic parts that are stuck to it (I used a scalpel for this). You would then insert it face-down into the 3d-printed key fob enclosure. I applied a small amount of super glue to ensure that the rubber button will not shift around. Once any glue is dry, you can insert the electrical components of the key fob and snap the enclosure together.
So far this has held up to one-month's daily use and does not show any signs of breaking down, shifting, or coming apart.