Spigen XR cell phone case kickstand

I downloaded a couple I found online.  They were all too big.  I tried scaling them but it became clear that the plastic post requirement of 1mm was not going to be strong or render well.  Then I realized that maybe this model was different.  The kickstand was gone, but there was a 1mm diameter steel post about 13mm long left behind.

This kickstand needs a metal post insert.  You could probably make one from a needle or pin it is so small.  I also added the notches back to the side so it clicks into place in the case.

This will print about 10mm wide and 38mm long.

I printed it in PETG on its side to give strength when jamming the post into place.

I printed this with a .4mm nozzle and .15mm layer.  The tolerance may be too much for some.  You get that one layer around the hinge. 

I might be .2mm or so too thick, but it works.