1 / 5
Sturdy coat/wall hook
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A sturdy coat hook for a wall, with recess to for flush fitting when used with a rawl plug or similar.
- Rating
- 4.8 / 5
- Likes
- 84
- Downloads
- 861
- Makes
- 17
- Views
- 1,812
- Reviews
- 15
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a simple sturdy hook that would sit flush to the wall even if using hardware that sits a little proud. e.g. A Rawl plug or plasterboard/dry wall fitting. The recess in the back is 1mm deep and 14mm in diameter.
Print at about 20% infill. The print orientation should be correct (prints best laying on its side) without support. Mine printed very well in PLA.
A counter sunk screw 4 or 5 x approx. 40mm for your wall fitting.