YAMMRH - Yet Another Magnetic Mount for Round Hygrometers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple magnetic mount for electronic Hygro/Thermometers. The magnets are embedded inside the structure.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 58
- Makes
- 0
- Views
- 444
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
This is a remix of the Round Hygrometer Magnetic Mount by thelonecabbage. I like this holder since it allows to mount the instrument in a recess, and the magnets are located right at the front.
Modifications
- Added slots to accommodate the mounting "tabs" that are found on these hygrometers.
- Two different slot positions allow to mount the entire setup either horizontally or vertically.
- Magnets are embedded in the holder (see below).


Parts
- 4x magnets 10 mm x 2 mm
- 1x Hygrometer Thermometer as shown in the pictures
- Your preferred 3D printer and filament
Printing
I printed this in white PLA with 0.2 mm layer height. Infill can be very low (10% or less) since there is no mechanical stress.
The magnets
To insert the magnets at the right time, you may want to pause the print:
- In PrusaSlicer, set up printing as usual and slice the model.
- In the Preview window, drag the layer slider to 5.6 mm. This is the layer that is at the "upper edge" of the magnet holes.
- Right-click the "+" icon and select Add pause print (M601). Click.
- Edit the short message and close the dialog with OK.

When you print this, the printer will stop (and, as of today, even switch off the heating). You can then insert the magnets. Then, on the front panel, select “continue printing” and the printer will print the last two layers over the magnets.
Important: As of December 2022, the layers following the Pause Print command will not be printed correctly if you print via Octoprint! You need to save the gcode to the SD card and print from the SD card. Guess how I found this out … 🤪

Color change
Instead of pausing the print, you could also introduce a color change and print the last two layers in a different color. If I remember correctly, this might also be a workaround for the Pause error described above (upon color change, you simply re-insert the same filament) but I did not try this yet. Feedback from OctoPrint-enabled PrusaPrinters is welcome :-)
Mounting
- Insert hygrometer in frame.
- Introduce hygrometer-in-frame into drybox.
- Use 2 magnets from the exterior to hold the frame in the desired position.
- Post a make and review 😋
- Enjoy 😀
The code
Big "Thank You!" to thelonecabbage for sharing your FreeCad source. I'm doing the same here :-)