Solid Small Wand Section
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The last part was a bit delicate so I made a solid version that can be swapped out with the hollow piece.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 71
- Makes
- 0
- Views
- 655
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Share Alike
After I printed the magic wand I broken the smallest section before the kids even touched it. I glued it up but wasn't happy with the likihood that it would break again. So I printed it solid and it has held up better. I should say that I didn't print it at 100% infill, only 20%. The strength comes from the internal structure. If you print at 100% it may actually be more likely to snap.
One important note, don't glue on the bottom if you want to swap out the orginal design with this solid part replacement.