Solid Small Wand Section
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The last part was a bit delicate so I made a solid version that can be swapped out with the hollow piece.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 655
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
After I printed the magic wand I broken the smallest section before the kids even touched it. I glued it up but wasn't happy with the likihood that it would break again. So I printed it solid and it has held up better. I should say that I didn't print it at 100% infill, only 20%. The strength comes from the internal structure. If you print at 100% it may actually be more likely to snap.
One important note, don't glue on the bottom if you want to swap out the orginal design with this solid part replacement.