Shelf Support Pegs (4 & 5mm pins)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick printing replacement part, even in PLA they can take a good bit of weight. These would be a bit stronger printed…
- Rating
- 5 / 5
- Likes
- 78
- Downloads
- 789
- Makes
- 12
- Views
- 1,582
- Reviews
- 11
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Quick printing replacement part, even in PLA they can take a good bit of weight.
These would be a bit stronger printed in 0.3 instead of 0.2 and with more infill, but if weight is that critical, your probably better off ordering metal parts.
The original version was a 5mm pin, but if that is too tight, you can either run a die over the pin to shave it down or switch to the 4mm pin file.
These were designed to print without supports.
Print Settings
Printer:
D-Bot CoreXY
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
75%
Category: Replacement Parts