Shelf Support Pegs (4 & 5mm pins)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick printing replacement part, even in PLA they can take a good bit of weight. These would be a bit stronger printed…
- Ocena
- 5 / 5
- Polubienia
- 78
- Pobrania
- 787
- Wydruki
- 12
- Wyświetlenia
- 1580
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Quick printing replacement part, even in PLA they can take a good bit of weight.
These would be a bit stronger printed in 0.3 instead of 0.2 and with more infill, but if weight is that critical, your probably better off ordering metal parts.
The original version was a 5mm pin, but if that is too tight, you can either run a die over the pin to shave it down or switch to the 4mm pin file.
These were designed to print without supports.
Print Settings
Printer:
D-Bot CoreXY
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
75%
Category: Replacement Parts