1 / 1
Magnetic 25mm RPG Miniature Base (Resin pre-supported) — image 1

Magnetic 25mm RPG Miniature Base (Resin pre-supported)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This remix is a pre-supported version for resin printing of the original things.

Rating
0 / 5
Likes
8
Downloads
96
Makes
0
Views
703
Reviews
0

Updated at source:

Model information

Category
Board Games
License
Creative Commons — Attribution — Noncommercial — Share Alike

This remix is a pre-supported version for resin printing of the original things. Supports were created manually in Lychee slicer and successfully test-printed.

I wanted the magnetic elite base add-on to be sandwiched around the magnet instead of only on one side, so I created a 1mm thinner version of the original elite base. This worked perfectly for me with 10x2mm round magnets. I did not create pre-supported files of the elite bases, as I printed them flat on the build plate with a flex plate and Lychee elephant foot compensation.

I did not use all types of tops available in the original things, but you can easily transfer the supports of my pre-supported tops (top-stone or top-tile) by opening them in Lychee, selecting the model in the "Layout" tab (top of window) and then replace the STL using the "Browse" button on the right side of the Lychee window. This will keep the supports intact while switching out the STL.

PS: the other tops might require additional supports; I did not check, so I recommend you do yourself.

PS2:if you're lucky, the tops can be printed flat on the build plate, but for some reason they did not stick for me on my flexplate. For the bottom pieces this is difficult as they are basically one huge suction cup. But if you can pull that off, it's probably superior and less work than what I uploaded here!

Post-Printing

Support removals for bottoms

To remove the supports, use your wire cutters to cut into the supports from multiple sides. I made 3-4 cuts like this and was then able to easily remove the remaining supports without further clipping side. This takes maybe 10 seconds per piece, but makes sure the very thin part of the base remains intact.

I lightly sanded the bottom before assembling.

Support removal for tops

To remove the supports of top parts, use your wire cutters to cut into the supports from one side, then twist your wire cutters to break the rest of the supports. This takes maybe 3-5 seconds per piece.

I lightly sanded the bottom before assembling.

Tags