Little bathtub tug boat
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.05 – €4.95 net (excluding VAT)
For file: ship_v3_015mm_pla_mk3.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €4.50 excluding VAT (range midpoint).
- Weight reported by the author
- 46 g
- Print time reported by the author
- 5 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Growth for my bathtub fleet. A little tugboat.
- Rating
- 4.857 / 5
- Likes
- 163
- Downloads
- 1,484
- Makes
- 29
- Views
- 5,760
- Reviews
- 21
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Growth for my bathtub fleet. A little tugboat.
I had seen a great 3d picture of a tugs and I couldn't get that out of my head. Unfortunately, I don't know where I saw it. So I tried to draw it out of my head. The model was created on this basis.
Even if my boats are not benchmarks (benchy), you can use them for quality control.
I drew two versions. One with open cabin and one with closed. The highlight of the open version is a variation of Larry the Engineer (Makerbot) as captain. The tug can be used on land, then you don't have to pay attention to anything. However, if it is to be floatable, the fuselage must be printed with two different fillings. Otherwise the boat is too light.
Print instructions
If it shall swim, two different infill
Bottom: 40-50% Infill
Top: 10% Infill