Dwayne The Rock Vader
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of Eastman's amazing Darth Vader.
- Rating
- 5 / 5
- Likes
- 75
- Downloads
- 266
- Makes
- 3
- Views
- 2,385
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These directons are straight from Eastman's original model for this figure:
The body
Now, the body part leans quite heavily, so put nice wide brim on it to keep it in place, and if it makes you feel safer put some supports down as well. The body can also be printed without infill, which is how I printed mine.
The base
The base needs infill until the three little "feet" end, but beyond that it can be printed without it. Shouldn't be any need on any printer for supports.
I printed this on my CR-10S using some PLA (from 3DNet, no affiliation), and the following settings (note this is just how I printed mine, not a straight out print guide):
Layer height: 0.12mm
Nozzle: 0.4mm
Perimeter: 1.2mm (3 perimeters)
Speed: 60mm/s (but S3D slows it down mostly)
Top/bottom # layers: 6
Infill: 10% rectilinear (on base)
Print time: Probably a total of 30 hours