ClockWork2 (CW2) hartk PCB cover with umbilical cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
CW2 hartk pcb cover with a rear facing 2 piece clamp
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 39
- Makes
- 0
- Views
- 1,130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a super scuffed (my cad skills at time of upload are horrendous) but functional remix of the hartk pcb cover for the CW2 extruder. I have a rear facing umbilical as I'm using the hartk 2 piece toolhead pcb set for my Trident, so making a rear facing umbilical cover for the CW2 sounded like a good idea. It also is completely open from the rear/bottom so you don't have to unplug or depin anything to use this cover.
This may get a redux sometime in the future, but thought I'd upload the scuffed version for now.
Fasteners:
4x - 3mm*4mm*5mm heatset inserts (typical voron spec)
4x - M3x20 SHCS
Installation:
- Install heatset inserts into the small clamp piece
- Remove SB front face + original CW2 extruder cover if installed.
- Install CW2 pcb + umbilical cover
- I personally install the bottom screw of the cover first, then install the screw which enables the rotating function of the cover. Refer to original manual for screw sizes, as these are the same sizes are the original CW2 cover.
- Hold umbilical in place with clamp piece
- Screw M3x20 through CW2 cover into the small clamp piece with the heatset inserts from earlier.
- Put SB front face back on and you're done!