Headphone hanger with hidden wall mount

A nice rounded wall hanger for a pair of headphones, this version has a hidden attachment. Choose from a smooth mounting bracket (I use this, attached by a 3M Command strip trimmed to fit) or a bracket with a single screw hole for a more permanent attachment.

Once bracket is mounted to wall, hanger slides onto it from above, hiding the bracket. I included two models for the bracket, one with a snug fit and another with a loose fit. Comments welcome!

Side note: hanger feels very nice in the hand, the rounded edges are quite pleasant. Fits fairly bulky headphone bands (Sony MDR-1A pictured), will likely fit a large range of models.

Print instructions

Category: Organization Summary

A nice rounded wall hanger for a pair of headphones, this version has a hidden attachment. Choose from a smooth mounting bracket (I use this, attached by a 3M Command strip trimmed to fit) or a bracket with a single screw hole for a more permanent attachment.

Once bracket is mounted to wall, hanger slides onto it from above, hiding the bracket. I included two models for the bracket, one with a snug fit and another with a loose fit. Comments welcome!

Side note: hanger feels very nice in the hand, the rounded edges are quite pleasant. Fits fairly bulky headphone bands (Sony MDR-1A pictured), will likely fit a large range of models.

Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0.2 mm

Infill: 15%

Filament: Atomic Filament PLA Silver
Notes:

Prints without supports when flat side is down, no overhangs >45 degrees in model (I think).