Sit-n-Scoop Kit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sit-n-Scoop! Designed after the favorite park/sand playset.
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 45
- Makes
- 1
- Views
- 404
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
Every section of this kit is configurable to fit the size and setup you want. Need a really long reach? More lift power? Higher base? Adult or kid sized, this is a very fun model to tweak the parameters on.
To make a full Sit-n-Scoop, you'll need to print these joints along with various lengths of 38mmx38mm (2"x2") wood (listed below).
If you're enjoying models like this, please consider supporting us on Patreon so we can continue making great content for you. https://www.patreon.com/oddinventor
What's Included:
This collection includes all of the 3D model joints needed to complete the Sit-n-Scoop
Additional hardware needed:
- 9 x 6000 bearings
- 1 x M10 [email protected] Bolt
- 4 x M10 [email protected] Bolt
- 11 x M10 Flat Washers
- 5 x [email protected] Nylon Lock Nuts
- 31 x 8mm (or 5/16") Steel Balls
- ~ 100 x 1" Deck Screws (not needed for every hole)
Lumber Needed:
The entire kit is constructed using only 2x2 lumber. You'll need at least four 8-foot boards, but it might be a good idea to pick up a few extra in case you make a wrong cut, or there are cracks/knots that you can't avoid.
Below is the suggested lengths to build a roughly-playground sized Sit-n-Scoop, but by all means: play around with the sizes and have some fun with it!
- Pull arms: 2 x 18"
- Base to Arm: 1 x 12"
- Seat Top: 4 x 12"
- Tetrahedron Base: 6 x 18"
- Bottom Arm: 1 x 20"
- Top Arm: 1 x 18"
- Scoop Arm: 1 x 20"