Sliding Hard Drive Rail for Sharkoon Gigabyte PC Cases
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3.5" sliding hard drive rail primarily for shucked disks
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 81
- Makes
- 1
- Views
- 599
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
A sliding hard drive rail for 3.5" drives. This is an extended length version designed for primarily for shucked disks which only have 2 instead of the typical 3 screw holes on either side. The rails which are included with the cases I tested don't work for these hard drives which have missing screw holes.
I've personally tested the design by fitting it to these PC cases:
- Gigabyte Poseidon
- Sharkoon Rebel 12
It's a standard design so will likely fit more cases manufactured in China during the same time period.
Printing tips:
My usual print settings involve a skirt or brim (with a 0.6mm gap). Print the model in the same way it's downloaded with supports for the two pegs which insert into the side of the hard drive. If you're using a brim in Cura then as a bonus you can add support brims, this helps to stop them coming unstuck.