Dual Fan Duct for SuperMicro 1U LGA2011 heatsink
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Attaches two 80mm fans to a 1U Xeon heatsink.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 75
- Makes
- 0
- Views
- 1,503
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
I bought an older SuperMicro server motherboard off ebay and it came with a low-profile 1U heatsink, which depends on airflow from some very loud fans, directed through the fins by the close-fitting top of the server chassis. Since I put the board into a standard desktop tower case, and I didn't want to use those loud fans, I designed a duct which glues onto the heatsink and fits two 80mm fans. I am currently using a pair of worn-out fans from an old computer case, one of which barely spins, and it still kept my 95W CPU down to 50C under prolonged load of all cores. The cutouts in the outside lower corners are to clear the memory - DIMMs can be installed and removed without taking off fans or the heatsink, though it's not easy. Also perhaps it'll spill a little bit of air across the RAM for some cooling.
I admit this would have made a lot more sense (and been easier to design) with a single 120mm fan, and/or if I started with a 2U heatsink, but I decided to go with the parts I had on hand.
The duct itself is glued to the heatsink with CA glue (all around the lower edges and the top of the fins, where they're connected to each other at the trailing edge of the print,) the mount screws are accessible with a suitably-long screwdriver through the fan intakes, then screw on the fans after the heatsink is attached to the motherboard.
Hardware required: 4 x E Z Lok 6-32 flanged threaded inserts (Part Number FL-632-HI - these are designed to be installed ultrasonically but they work just fine with a soldering iron.) 4 x 6-32x1-1/4" button head screws, 1x SuperMicro 1U LGA-2011 heatsink (tested with part number SNK-P0047P, based on pictures I believe that it would also fit SNK-P0057P or SNK-P0047PF parts.)
Heatsinks do get hot (hopefully not too hot,) so keep that in mind when choosing filament - PETG would probably be good, I tried HT-PLA, but (unsurprisingly, given all the thin sections) it warped during the annealing process, so that's not a good fit. I also tried HTPET+ (the prototype attached to the spare heatsink,) but I haven't dialed that in for my printer yet and it came out poorly, so I ended up with Overture Nylon, which survived the annealing process with very little distortion. Overture claims a 180C operating temperature, which I suspect is totally made up, but hopefully it'll tolerate at least 80C.
I have also attached the FreeCAD model, but I made some mistakes and it's kind of a mess, so good luck - use FreeCAD v0.20.1 for the least-bad results.