1 / 7
XT30 Balance Board (3S + 4S)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
You will need JST 3s and 4s connectors for the balancer and also XT30 Plugs to charge the batteries.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 23
- Makes
- 0
- Views
- 394
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You will need JST 3s and 4s connectors for the balancer and also XT30 Plugs to charge the batteries. I glued all the connectors in place with epoxy and then soldered the cables.
I did't have to glue the bottom and the top plate together, it was a tight fit. Check for shorts with a multimeter before connecting a battery!
Print instructions
Print Settings
Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: No
Resolution: 0.2
Infill: ~20%
Notes:
I printed mine out of PET-G but PLA should also be fine