RELAY Snap Fit CASE - M3 Hardware - 2040 4040 (70x17mm)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Extrusion mountable snap fit case for a common single relay board. (70x17mm)
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 34
- Makes
- 1
- Views
- 224
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A very robust, yet minimal case designed for single SRD relay boards sized approximately 70x17mm.
Prints fast, clean, and small - pop it off the build surface, and use it instantly.
Mounts to 20XX, etc with M3 Hex Cap Bolts - use printed M3 t-nuts to secure.
Optional M2 holes that can be threaded into, that also pass thru the bottom.
Insert the relay end first, into side #1, than snap down remaining side.(#2)
![]() | ![]() |

Not much to this model(6g/2m) -printing at any layer height/line width/nozzle/etc should do.
PARTS (if mounting):
2x M3x6 Hex Cap Bolt
2x M3 T-Nut
---
if mounting board:
4x M2 Hex Cap Bolt

