1 / 9
RELAY Snap Fit CASE - M3 Hardware - 2040 4040 (70x17mm) — zdjęcie 1
1 / 9

RELAY Snap Fit CASE - M3 Hardware - 2040 4040 (70x17mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Extrusion mountable snap fit case for a common single relay board. (70x17mm)

Ocena
5 / 5
Polubienia
5
Pobrania
34
Wydruki
1
Wyświetlenia
225
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

  A very robust, yet minimal case designed for single SRD relay boards sized approximately 70x17mm. 

Prints fast, clean, and small - pop it off the build surface, and use it instantly.

Mounts to 20XX, etc with M3 Hex Cap Bolts - use printed M3 t-nuts to secure.
Optional M2 holes that can be threaded into, that also pass thru the bottom. 

Insert the relay end first, into side #1, than snap down remaining side.(#2) 

 

 

Not much to this model(6g/2m) -printing at any layer height/line width/nozzle/etc should do.
 

PARTS (if mounting):

2x  M3x6 Hex Cap Bolt

2x  M3 T-Nut

---

if mounting board:

4x M2 Hex Cap Bolt

 

Tagi