Unifi AP Lite Wall mount JUNG LS 990
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
With this model you can mount the AP directly on your European wall socket inside a JUNG LS 990 frame.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 77
- Makes
- 1
- Views
- 1,398
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This is a wall mount for a Unifi UAP-AC-Lite, U6-Lite and I believe also the LR versions. It will fit a JUNG LS 990 frame and assumes a single UTP socket. I used a Rutenbeck UTP element, But I think it will fit others as well.
I tried designing it without the need for supports but this never turned out very functional, so I'm afraid you'll need to print with supports. I strongly suggest using PETG, since I expect the key to otherwise break very quickly. I printed at 3 perimeters, 15% infill and 0.2mm layer height.
The design I used is with the mounting holes on the sides, but while mounting I noticed I only needed the screw in the middle, so I also made a somewhat simpler design without the holes, it should require less supports. I have not tested this print though.
I've added the step files as well in case you want to adjust things. Be warned that I realised a bit late that I was going to publish it, so the naming scheme is a mix of dutch and english.
It is quite specific and maybe somewhat overdesigned, but isn't that the point of 3D printing :)