Unifi AP Lite Wall mount JUNG LS 990
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With this model you can mount the AP directly on your European wall socket inside a JUNG LS 990 frame.
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 1398
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a wall mount for a Unifi UAP-AC-Lite, U6-Lite and I believe also the LR versions. It will fit a JUNG LS 990 frame and assumes a single UTP socket. I used a Rutenbeck UTP element, But I think it will fit others as well.
I tried designing it without the need for supports but this never turned out very functional, so I'm afraid you'll need to print with supports. I strongly suggest using PETG, since I expect the key to otherwise break very quickly. I printed at 3 perimeters, 15% infill and 0.2mm layer height.
The design I used is with the mounting holes on the sides, but while mounting I noticed I only needed the screw in the middle, so I also made a somewhat simpler design without the holes, it should require less supports. I have not tested this print though.
I've added the step files as well in case you want to adjust things. Be warned that I realised a bit late that I was going to publish it, so the naming scheme is a mix of dutch and english.
It is quite specific and maybe somewhat overdesigned, but isn't that the point of 3D printing :)