Micro SD card Keychain/Neckless

Description-

Lossing your micro-SD card all the time when moving files from a Pc/Laptop to your 3D printer? I'm on bored with that statement! 

This micro-SD card keychain hopefully will keep you from losing any more micro-SDs. 

Instructions- 

This is how I 3D printed the parts. 

These pieces should fit together pretty tightly. If there two tight, shave off a little tiny bit of plastic in the places circled red.

If you're having problems not being able to pull out your micro-SD card from this keychain you may need to shave off a little bit of material along the sides, which are also circled red. 

I made it so that both low and high tolerance printers can produce good fitting parts. Some may need to shave off a little bit of material, and some may not need to! 

I Recommend gluing Micro SD card neckless-1 0.4 and Micro SD card neckless-2 0.3 together with superglue or plastic weld. MAKE SURE YOU CHECK IF YOUR MICRO SD CARD FITS PROPERLY IN Micro SD card neckless-1 0.4 BEFORE GLUEING!

I hope everything prints well for you! 

PRINTER-

layer height- 0.125mm

Line width- 0.2mm

Infill- 100%

Speed- 50%

Supports- No

Raft- Up to you

Time- Close to 1 hour and 10 minutes for both parts 

Extras-

If you have any questions let me know! I'm all for recommendations, if there is something you would like to see changed feel free to tell me! 

Thank you-