Langmuir Systems XR Controller Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enclosure for protecting your Langmuir Systems XR wireless controller from impact damage.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 51
- Makes
- 1
- Views
- 447
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
I designed this to add a degree of impact protection to my Langmuir Systems XR Plasma Torch Table wireless controller. I used Prusament filament (galaxy black) which I highly recommend. For higher temp stability, try an ASA filament, or ABS. I would not use PETG as the panel piece is bonded to the bezel piece and PETG does not bond well (that I know of).
The housing is designed to accept 4-40 brass threaded inserts. I heat-inserted these using my soldering iron. These inserts can be bought at Amazon or McMaster-Carr, etc.
The thin control panel piece was made separate so that it could be superglued or solvent bonded in place with either the smooth bed-side up or down, your choice. I wanted the rougher matte finish of the as-printed side of the panel. Some may prefer the shinier bed-side of the panel. Some may get adventurous and print this on a Prusa textured sheet for a nifty textured panel. You could also combine it into the bezel piece and make a one piece cover. I have included .step files for those with CAD experience. PLA, ABS and ASA will all super glue and you could use solvent with ASA or ABS.
I added a bumper to wrap the enclosure. I am going to print this in TPU, but I have not yet tried, so proceed at your on risk!!
Good luck!