Storage base for PCIe cards
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is modified to be thick and tall enough for cards to fit without the card bracket sticking below
- Rating
- 4 / 5
- Likes
- 48
- Downloads
- 330
- Makes
- 4
- Views
- 1,535
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
The original base had to sit on the edge of a shelf so that the bottoms of the PCIe brackets could stick down. I wanted more flexibility, so I added height to the unit. This lets the cards fit without protruding too far.
I also stretched the whole model just slightly to make the slots less snug. I found many cards so hard to put in I was concerned about damage to the interface when I printed it, so I gave it a couple percent stretch. I then removed a little on the ends that was wasted space (and filament) and took off the slope at the ends of the slots to let the cards fit better.