Risers for pinball cabinets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Raise a too-short pinball cabinet to a more comfortable playing height.
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 167
- Makes
- 1
- Views
- 785
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a couple of not-standard-size virtual pinball machines. Even with their feet extended, I find them a little too short to be comfortably played. I made these to put undr the feet to raise the cabinet to a more comfortable height. They're very stable and don't slide on carpet. However you'll need some "rubber" pads to keep them from sliding around if you're using them on hardwood or tile floors. I've been using them for over a year with no problems.
I've made these risers in three sizes that will raise the cabinet 25, 30 or 50 mm (approx 1, 1.25, 2.0 inches) - measured from floor to top level of the inset cup. I find the 50mm set works best for me on my mini cab and the 30mm set works well on my AtGames Legends Pinball (ALP) cabinet.
You should print with a good infill percentage (approx 20%) and a minimum of 4 top layers - you're going to be holding up a bit of weight.