Bambu Dry box AMS Hygrometer Silica Gel

I had changed all my box to v3, please use my AMS dry box center v3.3mf for print.

If the hygrometer(some is so big) is a little small, please use same paper to fit it(I used it in photos).

For drying Bambu AMS box, you can directly add color-changing silica gel desiccant, non-toxic orange desiccant is recommended.

Many designs were referred to,more than 20, but none of them could meet the requirements, so the model is a new drawing designs.

Compared with other dry boxes that can be searched:

1. The capacity is increased, and more desiccant can be put in;
2. The position of the square temperature and humidity meter has been raised to ensure that the humidity can be seen directly when there is a toolbox (https://www.printables.com/model/272099-bambu-lab-carbon-x1-with-ams-top-tool-storage) in front;
3. Smaller gaps to ensure that the silica gel particles will not fall out;
4. More dense openings and a reasonable internal transition layer ensure that it can be easily printed without internal support and opening support;
5. The narrower feeding port will not interfere with the feeding tray;
6. The bayonet of the feed port is tighter and has an anti-off device to ensure that the cover will not fall off easily.

thanks for@Fangoh .This is the hygrometer what he purchased: https://www.amazon.com/dp/B08P3QJJZL It worked perfectly.

Version Information:

V3.0
thanks for suggestion of @Squawk_388463, I remove some 'ribs' and have tested it.
I upload the .3mf file, so you can print it directly.

V2.1
Modified hygrometer position dimensions of “AMS dry box center” to accommodate more tolerances,and added a version without the hygrometer mount for PLA.(Advised by makerdog)

V2.0
The original version for publish.

Buy me a coffee

If you like my work, you can buy me a coffee. Appreciated !