M5 flange for 1/4" NPT mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount 1/4" NPT (tapered national pipe thread) on anything with M5 screws.
- Rating
- 5 / 5
- Likes
- 24
- Downloads
- 117
- Makes
- 2
- Views
- 858
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount 1/4" NPT (tapered national pipe thread) on anything with M5 screws. Used in my case to mount Loc Line on the side of my Prusa MK3S to hold a camera and a light for my OctoPrint instance.
There's also a cutout in the bottom which would allow wires to be routed through and exit the flange - could be useful if you run the wiring through the LocLine in with my T10 light shade.
There was a very similar thing that I downloaded and printed quite some time ago - I tried to find it again but was unable so designed this from scratch in Fusion 360. I used a McMaster 1/4" NPT pipe cap as the starting point since Fusion 360still can't model tapered pipe threads, and then designed from there.
Print instructions
Print as-is with no supports. 0.2mm layer height should work with a 0.4mm nozzle, higher might make the threads a bit messy. Infill isn't terribly important, up the shells if you're concerned about strength, but this is not going to hold pressure or significant weight.