IKEA RÅSKOG trolley locking clips
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.50 – €1.84 net (excluding VAT)
For file: clip2_02mm_petg_mk3s_1h54m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.67 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 1.91 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Remix (actually a new openscad file, based on the original geometry) of the modular trolley clips from @EvilSpyBoy.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 104
- Makes
- 0
- Views
- 941
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Remix (actually a new openscad file, based on the original geometry) of the modular trolley clips from @EvilSpyBoy. Fully compatible.
This variation has a small locking tab that will help keep any accessories firmly attached, since i had issues with the original clips sliding off a little too easily.
Openscad file included in case you'd like to improve upon it.
Print instructions
Printed in PETG, 20% infill, 2 perimeters, 0.2mm layer height, no brim, no supports.
The included gcode file is for an MK3S, PETG, and prints a set of 2.