1 / 11
House connector for HEATBED Ratrig Vcore
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple design for Ratrig to make the printing plate removable easily.
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 53
- Makes
- 1
- Views
- 1,049
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple design for Ratrig to make the printing plate removable easily.
The connector used is a CNLINKO LP-12 4 PIN.
2 Pin for bed thermistor and 2 pins for 220 V power supply
You will need to solder the wires, the connector should hold power up to about 1000 watts.
Printing requires only a few supports, to support the threaded part that goes into the panel.
After printing you should be able to move the 2 parts.
Use a 0.4 nozzle and set a flow not too wide , to allow the design to work;