Boat Propeller 20cm, 13cm and 10cm diameter, 10mm shaft
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Boat Propeller I designed to electrically drive my canoe. It can be driven with a battery drill
- Rating
- 4.833 / 5
- Likes
- 159
- Downloads
- 3,137
- Makes
- 13
- Views
- 9,349
- Reviews
- 12
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial
Boat Propeller I designed to electrically drive my canoe. It can be driven with a battery drill.
Edit: /* To clear things up a bit.
20cm_10mm.3mf is a propeller with 20cm diameter and a hole for a shaft with 10mm diameter. 30° tip angle; 314mm/rev pitch
20cm_15mm.3mf is a propeller with 20cm as well and a hole with 15mm diameter.
NEW Model: 13cm_10mm_flat.3mf has 13cm diameter and 10mm shaft, it is a bit flatter and has a less “aggressive” angle. Better for low torque and higher RPM motors. 30° tip angle; 204mm/rev pitch
NEW Model 2: Parametrised_MK7_10cm_10mm_flatter.3MF
10cm diameter 10mm shaft; 30° tip angle; 157mm/rev pitch;
13cm_10mm_flat.3mf and the 10cm version need support.
Scale any of them to fit your needs ;-)
*/
There is a version with a 15mm hole that can be scaled down to 66,67%(20cm_15mm.3mf) in the slicer to get the 13cm diameter propeller with a 10mm hole. Or you scale down the 20cm(20cm_10mm.3mf) one to 60% to use it with a 6mm shaft.
Use M5 screws to fix on the shaft.
The print time indicated is for the 66% version.
The smaller version is easier to handle and more adequate in size for a small canoe, however it needs higher rpm (+-2000rpm) to work well.
Print instructions
Can be printed without support. I printed it in ABS.
13cm_10mm_flat.3mf needs support.