Gravitrax spacer Fast and Spiral (3,4,5,6,8,10u)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
this is gravitrax spacer (pillar, tower?) designed to be printed in vase/spiral mode.
- Rating
- 4 / 5
- Likes
- 16
- Downloads
- 169
- Makes
- 2
- Views
- 982
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Building Toys
- License
- Creative Commons — Attribution — Share Alike
I thought that it should be pretty easy to design spiral-mode gravitrax spacer, but yet I couldn't find any - so I designed one. It prints fast and uses as little filament as possible. So if You have 8 grams of filament and 15-20 minutes - give it a try :) (15 grams and 30 minutes for 10 unit piece)
How to print tips:
- Print it wit 0.8 line width (spiral mode of course)
- Technically it is designed so it doesn't need any bottom layers, but for better adhesion you can set 3 bottom layers.
- If you want more - print them sequentially (mind collisions with X carriage)
Additional thoughts:
With 0.8 mm line width 3-unit piece weights 9 grams - so it is perfect for filament leftovers. The 10-unit part weights only 15 grams and prints in 30 minutes (layer height 0.4 and high flow nozzle). Probably I will improve this in the future - some extra indents to improve wall stiffness and modify latch part so it holds better, but as it is now it's fully functional and strong.