1 / 2
SSD Mount compatible w/ Phanteks Enthoo Series
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 3D-printable SSD mount for the Enthoo series of cases
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 67
- Makes
- 0
- Views
- 377
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
An SSD mount for the Phanteks Enthoo series cases. I tried this model previously:
https://www.printables.com/model/202088-ssd-tray-phanteks
and found it to be lacking in a few areas:
- Side walls are thin and fragile
- Slightly undersized in width
- Bottom slots squeezed the rubber grommets too much for my liking.
I redesigned it from scratch to instead use the bottom mounting holes on the SSD instead of the side mounting holes so that it can print as a flat slab. It will be a bit flexible on its own but gains rigidity once you attach it to the SSD.
Print Settings:
- No supports required as the screw hole countersinks have inbuilt bridging.
- 0.2 mm layer heights
- Print with the large flat side facing down.
Instructions:
Just print, bolt on your SSD, and snap onto the mounts in the case just like the original.