Small Bracelet 15x12x5 mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hi, this is my take on creating a small bracelet that could be easily 3D printed and assembled. Each "Master" adds…
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 64
- Makes
- 0
- Views
- 459
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution
Hi, this is my take on creating a small bracelet that could be easily 3D printed and assembled. Each "Master" adds about 12 mm to the bracelet, I use 15 of them +the lock on my wrist, so maybe print around 16 the first time and see if you need more.
i hope you like this model and feel free to contact me for any question or doubt you might have
Thanks!
IMPORTANT: READ NOTES BELOW!
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
No
Resolution:
I recommend 0.15 mm but I'm pretty sure it could work with 0.2 mm as well
Infill:
No need for a high infill, I went for 15%. Make sure to increase the wall thickness to at least 2 per side and 2 for top and bottom, though.
Notes:
DO NOT SCALE: this could interfere with the 0.4 mm clearance I chose. Feel free to ask for bigger / smaller (even though I don't think you'll want anything smaller than this) versions of this model.
Print the model at a relatively comfortable speed and high retraction to avoid messing up. I used the highest retraction Cura offers; 30 mm/s print & 50 mm/s travel speed
The lock system can be difficult to use the first times (you need to rotate the pieces as shown in the last picture).
TO CONNECT THE PIECES: insert some !! 1.75 mm !! PLA / any other material in the holes of the pieces as shown in pic #5
I hope you like this model!
For any question, reach me in the comment box!
Category: Bracelets