1 / 2
Kawasaki Z650RS - License Plate Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replaces the entire rear section of the bike.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 25
- Makes
- 0
- Views
- 768
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Print instructions:
- This should print without supports. I was able to print it laying on the large flat side down.
Bike Instructions:
- Remove the seat
- Remove the four 4mm bolts from the rear trim
- Remove the rear trim, gently pulling on the three rubber grommets that hold it in place
- Disconnect the electrical connectors that are inside the small rubber flap
- Remove the four 6mm bolts that connect the rear tail
- From here you should be able to pull out the tail piece
- On the tail, remove the 3mm bolt that holds the two nut brackets
- you will need these to connect the print back to the bike
- Place those brackets in the print, and secure them with the 3mm bolts
- Secure the printed part to the bike using the 6mm bolts
- Replace the rear trim and the bolts for it
- Replace your seat
Additional info:
- This removes your rear turn signals. I replaced my rear taillight with this
- This also doesn't have a white light for the license plate