Kawasaki Z650RS - License Plate Bracket

Print instructions:

• This should print without supports. I was able to print it laying on the large flat side down.

Bike Instructions:

• Remove the seat
• Remove the four 4mm bolts from the rear trim
• Remove the rear trim, gently pulling on the three rubber grommets that hold it in place
• Disconnect the electrical connectors that are inside the small rubber flap
• Remove the four 6mm bolts that connect the rear tail
• From here you should be able to pull out the tail piece
• On the tail, remove the 3mm bolt that holds the two nut brackets
  • you will need these to connect the print back to the bike
• Place those brackets in the print, and secure them with the 3mm bolts
• Secure the printed part to the bike using the 6mm bolts
• Replace the rear trim and the bolts for it
• Replace your seat

Additional info:

• This removes your rear turn signals. I replaced my rear taillight with this
  • https://www.motodynamic.com/2018-2023-kawasaki-z900rs-z650rs-sequential-led-tail-lights-smoke.html
• This also doesn't have a white light for the license plate