HSW Govee H6076 Floor Lamp horizontal mounts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remove the base from the lamp and hang it on your Honeycomb Storage Wall
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 63
- Makes
- 1
- Views
- 1,467
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial
I bought a Govee H6076 floor lamp a while back and used to lie it flat on top of a desk to get some ambient light behind me when working/streaming. I decided since I was going to fill the wall with Honeycomb Storage Wall plates that I might as well design some custom plugs, pull the base off the lamp, and mount it on the wall.
I used a filled-in single plug model, and measured and designed the plugs to fit over the base (which is a full circle, and the metal of the lamp's post has a flat edge on it), as well as a round open clip to let the rest of the lamp/bar rest in along the wall, which is only 75% of a circle so it doesn't block any of the light.
There are two designs here, “A” and “B”, depending on whether your HSW is hung with the “flat” edge of the HSW holes parallel to your floor, or if the “flat” edge of the HSW holes parallel to your wall. I used the “B” orientation for my build, and used one “bar” clip from the “A” orientation to help hide the wire behind the workbench.
I printed the plugs upside down (circles facing the print bed and the plug in the air), with support blockers on the plug end to reduce the support material. Orient the STLs however it makes sense for your printer and experience. I found that printing them plug-side down (plug on the bed) had trouble with supports around the overhangs on the plug, and including supports on the plug were too tedious to remove.
I'm always happy to take feedback on my designs!
My print settings:
Printed in Polymaker black ASA, and white PolySupport on a Bambu X1C/AMS
0.2mm layer height
4 perimeters, 5 top/bottom layers
20% grid infill
My HSW is made in PETG, and these fit in without any hammering.