1 / 4
Vixen-style dovetail bar for (Svbony / Orion) Guide Scope — image 1
1 / 4

Vixen-style dovetail bar for (Svbony / Orion) Guide Scope

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Vixen-style dovetail bar for (Svbony / Orion) Guide Scope

Rating
0 / 5
Likes
9
Downloads
141
Makes
0
Views
1,148
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Standard Vixen-stlye dovetail, with holes for Svbony / Orion Guide Scope rings, and Svbony dovetail clamp.

Versions:

  • The 90mm version is the same length as the original finder-dovetail. 
  • The 120mm adds a bit extra length for balancing.

Mounting:

Standard: 

The original M5 Allen-bolts came with the guide scope can be used with this dovetail to mount the tube rings, no need for new set of screws.

Reverse-clamp:

The Svbony dovetail clamp (35mm hole centre distance) can be also mounted “upside down” for reversed Vixen-plate mounting. For this, 2pcs. M6 nuts shall be placed inside during printing. Then two M6*16 or M6*20mm bolts are needed to mount the dovetail clamp onto the bar.

The “SvbonyDT_Insert” is an insert ring for the dovetail clamp's 8.5mm hole to tightly accommodate the M6 Allen-bolts. Unfortunately it's hard to find M8 screws that fit in the countersink hole on the clamp, so it is easier to use M6 bolts. The insert is a tight fit, prints in a few minutes, some fine tuning might be needed on different printers.

Settings: 

I printed mine from PETG with 6 perimeters, 100% infill. It took 3h59m and 85g filament. It is very sturdy. A lower (40-50%) infill might work as well.

The bottom of the countersink holes are filled with a 0,2mm extrusion to be able to print the part without using supports. You can drill through it with a 5mm drill, or just with the screw after printing.

 

Fusion360 .f3d files added to make customizations easier.

Tags