Vixen-style dovetail bar for (Svbony / Orion) Guide Scope
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vixen-style dovetail bar for (Svbony / Orion) Guide Scope
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 141
- Wydruki
- 0
- Wyświetlenia
- 1148
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
Standard Vixen-stlye dovetail, with holes for Svbony / Orion Guide Scope rings, and Svbony dovetail clamp.
Versions:
- The 90mm version is the same length as the original finder-dovetail.
- The 120mm adds a bit extra length for balancing.
Mounting:
Standard:
The original M5 Allen-bolts came with the guide scope can be used with this dovetail to mount the tube rings, no need for new set of screws.
Reverse-clamp:
The Svbony dovetail clamp (35mm hole centre distance) can be also mounted “upside down” for reversed Vixen-plate mounting. For this, 2pcs. M6 nuts shall be placed inside during printing. Then two M6*16 or M6*20mm bolts are needed to mount the dovetail clamp onto the bar.
The “SvbonyDT_Insert” is an insert ring for the dovetail clamp's 8.5mm hole to tightly accommodate the M6 Allen-bolts. Unfortunately it's hard to find M8 screws that fit in the countersink hole on the clamp, so it is easier to use M6 bolts. The insert is a tight fit, prints in a few minutes, some fine tuning might be needed on different printers.
Settings:
I printed mine from PETG with 6 perimeters, 100% infill. It took 3h59m and 85g filament. It is very sturdy. A lower (40-50%) infill might work as well.
The bottom of the countersink holes are filled with a 0,2mm extrusion to be able to print the part without using supports. You can drill through it with a 5mm drill, or just with the screw after printing.
Fusion360 .f3d files added to make customizations easier.