SV06 RF Smoke Detector Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount for an RF smoke detector to shut off printer power. Made for Sovol SV06 printer.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 26
- Makes
- 0
- Views
- 423
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mount for a small smoke detector. I made it for this smoke detector (https://www.tindie.com/products/niujl123/smoke-alarm-for-3d-printer/), which can cut power to an outlet via RF signal when smoke is detected. I made this to attach to the top of a Sovol SV06, although I'm sure a remixed base will allow someone to attach it to any other printer. The mount should not interfere with the extruder as I limited how much it drops below the frame to snap on.
I printed mine in PETG at 0.20mm layer height, 15% gyroid infill, and have been using it without any problems for 2 weeks now. The smoke detector slides in snugly and vibration from the printer does not make the mount move or fall down.
I found the best orientation to print in is the way I placed it in the file, laying on its side. You will most likely need some supports, and I used the new tree supports “touching buildplate” in Cura 5.3.0 xmas edition and enabling support interface.