MK3S housing for Raspberry A+ and EINSY RAMBO board
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This housing was designed as alternative solution to the original PRUSA housing for the RAMBO board, which allows only…
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 56
- Makes
- 0
- Views
- 947
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This housing was designed as alternative solution to the original PRUSA housing for the RAMBO board, which allows only an Rasperry Zero to fit in. The Raspberry Zero is however a little weak for using with OctoPrint with Video Streaming the 5MP Raspberry camera.
So I decided to swap the Raspberry Zero against a Raspberry A+ board and I wanted to connect the RaspiA+ in the same way which is used for the RaspiZero. So no additional power supply is needed and it works very well. I can now remotely control and observe my Prusa MK3S from the 1st floor while it is printing in the basement.
Print instructions
Printing with supports is recommended