1 / 8
5x Button Macroboard with JST-XH connector
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Macroboard with 5* 12x12mm buttons
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 31
- Makes
- 0
- Views
- 585
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
This is a very compact design for a 5 button macro board, that requires a bit of hardware you might have laying around
Printsettings:
- 0.2 or 0.15 layerheight
- at least 2 walls
- each at least 6 top and bottom layers
- 20% infill
- Material: PLA, PETG or ABS
BOM (might alter for you depending on how you connect it later):
- 4x M3x6 SHCS (for backplate)
- 2x M3x8 SHCS
- 4x M3 5mm long heatinserts
- 1x JST-XH 6pin (board side)
- 1x dupont 6pin (pi side)
- 5x 12x12mm button like this
- some thin wire
instruction:
- Cut plastic pins on the backside of buttons flush
- straighten the pins
- insert buttons fully into top part
- bend button pins inward
- insert jst connector
- solder cables up like in picture 2&3
- insert heat insert into front part
- input m3x8 into bottom part
- screw on backplate with m3x6
- prepare a cable 1:1 Jst to dupont
- prepare klipper config and insert [include micromacro.cfg] in printer.cfg
- plug dupont into pi (GND is right pin looking from the front)
Happy printing! please make sure to post a make.