1 / 1
[Printer-Box] Modular Control - Raspberry Pi Back Panel — image 1

[Printer-Box] Modular Control - Raspberry Pi Back Panel

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A revised back panel to accommodate the Raspberry Pi better on the [Printer-Box] modular control panel.

Rating
0 / 5
Likes
6
Downloads
33
Makes
0
Views
405
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Printer-Box created a really nifty modular control panel for their enclosure and as a stand-alone option. There was one part of this I wanted to make a change to and that was the back panel meant to accommodate a Raspberry Pi.

The changes I made were largely due to using a “Geekworm" 11mm heatsink to keep my Pi cool. While it fit the original design, I added a bit more headroom which also helps with clearance for the camera ribbon.

Speaking of the camera, I also added a slot for the camera ribbon to pass through. This felt a little more intentional than just sandwiching it between the case and the plate.

Outside of that I rounded a few edges and added some fillets, but otherwise left the original geometry intact. As such it fits in place just like the original.

Tips

  1. Slice your own file for best results.
  2. You will need a support for the bump-out portion.
  3. Apologies for the bad photo here, I forgot to take one before I went and installed it.

Tags