Kingston FCR-SH4 card reader holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I advise printing it standing to maximize layer strength, rotated 45 degrees to get even cooling for a nice finish (as…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 1
- Views
- 191
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
I advise printing it standing to maximize layer strength, rotated 45 degrees to get even cooling for a nice finish (as is the file right now), with a 5mm brim.
There are 3 Versions, each version is a bit wider than the last as V1 was a bit too tight. Each consecutive version is wider by 0.3mm.
I was satisfied with V1 but I made versions for people to choose at their own discretion.
Some post process may be required to round off any drooping may occur.
Should you wish to make modifications, and need it aligned to an axis, rotate -45 degrees.
https://www.reddit.com/r/3Dprinting/comments/ehknck/am_somewhat_proud_of_this_one_card_reader_mount/
If you find this useful or entertaining enough, tips are welcome. :)
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
Yes
Filament: DevilsDesign PETG TransparentRed
Notes:
I advise printing it standing to maximize layer strength, rotated 45 degrees to get even cooling for a nice finish (as is the file right now), with a 5mm brim. rnrnThere are 3 Versions, each version is a bit wider than the last as V1 was a bit too tight. Each consecutive version is wider by 0.3mm. rnrnI was satisfied with V1 but I made versions for people to choose at their own discretion.rnrnSome post process may be required to round off any drooping may occur.rnrnShould you wish to make modifications, and need it aligned to an axis, rotate -45 degrees.rnrnhttps://www.reddit.com/r/3Dprinting/comments/ehknck/am_somewhat_proud_of_this_one_card_reader_mount/
Category: Tool Holders & Boxes