1 / 4
Bambu Lab - Poop Bucket, Filament Waste Bin - X1 and X1 Carbon — image 1
1 / 4

Bambu Lab - Poop Bucket, Filament Waste Bin - X1 and X1 Carbon

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Poop bucket/filament waste/purge bin for the BambuLab X1 and X1 Carbon, probably suitable for P1P also.

Rating
4.773 / 5
Likes
781
Downloads
15,387
Makes
50
Views
63,041
Reviews
44

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution

UPDATE 3: I have now added a fourth version as per request by someone in the comments. This fourth version is both shorter and narrower. I have also removed all files and reuploaded with better naming as it was getting confusing:

V1.0 is the original remix, deeper bucket with logo.
V1.1 is the shortened version, allows for use with rear spool holder.
V1.2 is the narrower version, allows for closer position to wall etc.
V1.3 is shortened and narrower. 

-

UPDATE 2: I have also added 'Narrower' Version. The bottom section width is originally 95.25mm - but the narrower version is now 75mm width.

-

UPDATE: Added the 'Shortened_Height' Version. This is more suitable for use with the rear spool holder. Top edge is 25mm lower than the original.

-

I remixed this as some of the other versions out there are very chunky - but I liked the original POOPY SHOE by RAMServices1959 as it's much nicer - but it didn't have a logo on the part and bucket is quite shallow.

I wanted to make the lower bucket a bit deeper so it could hold more waste as I'm lazy and don't want to have to empty it too often.

Poop should fall out of the back, slide down into the lower bucket and then it's easy to just grab a handful out and put into my filament recycling.

I've included Bambu 3MF files, STEP files and STL files for each of the version, so please pick which you prefer.

Single-part, multi-colour print.

Yes, it's a big part - import it > orient it > rotate it away from 'keep-out' zone > right-click > centre it.

You may need to move the Purge Tower to a more suitable location, unless using the 3MF.

Thanks!

Tags