Tripod plant trellis bracket for wooden stakes
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This bracket allows you to attach 3 square hardwood stakes together into a single, freestanding plant trellis.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 39
- Makes
- 0
- Views
- 782
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution
The bracket has a cleat built into each side which interfaces with a wood-screw head protruding from each stake (see images). This is the minimum (3 screws) that is required for this, and might be easier for stakes you want to remove later.
For better structural stability, or to make the tripod able to stand freely without being driven into the ground (or if you plan to move it around a lot), there is a hidden screw hole on each surface at the bottom, providing a second point of contact.
Finally, there is a single screw hole at the very top/centre of the bracket in case you need a rigid mounting point for either a string trellis, or a decorative piece of twine.
You can pair this with my string trellis ground anchor for a variety of string trellis options!
Assembly Instructions (see assembly image):
- (optional) Drive a screw halfway into the centre hole, wrap your string/twine around it, and finish screwing it down while holding the twine towards the small cutout next to the screw hole. (I'm using a 50cm piece of decorative twine in the images, but it can be the middle/end of a string trellis instead!)
- Drive a screw into the face of each stake around 22cm (or your chosen distance) from the top of each.
- Slot the stakes onto the bracket (narrow end up) by aligning the screw with the cleat indentation, and pushing the stake UP. You should feel it slot into place with a small amount of friction. If this is too loose or tight of a fit, adjust the protrusion of the screw and try again. If you are adding the extra screw (see optional below), perform step 3 for each stake individually.
(optional for a free-standing or structurally beefy tripod)
Making sure that the screw from #2 is firmly in the cleat, drive a screw into the angled hole at the bottom, and firmly screw it down. The cleat should now be held firmly to each stake.
You'll need to drive the final optional screw while the tripod is assembled and free-standing with a thin screw-driver. - Wind your plant around it. Do stuff with the strings maybe.
world → oyster
Material Sizing:
There are 2 versions, one for socket-head screws that have a 6.3mm diameter head (robertson #1), and one for socket-head screws that have an 8mm diameter head (robertson #2, ‘standard wood screw’).
The screws I used have 15mm of threaded length, but 10mm should be enough.
The wooden stakes I used are approximately 20x20mm (¾"x¾"), and 1.83m (6') long, although any length of stake is fine; you can find these in 10-packs in most garden sections.
With the 6-degree angle, this results in around 25cm (10") of diameter at the bottom of the stakes.