1 / 2
Prusa MK3S/+ X-Carriage for Igus Drylin RJ4JP-01-08 — image 1
1 / 2

Prusa MK3S/+ X-Carriage for Igus Drylin RJ4JP-01-08

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Preliminary estimate for PETG

€3.27 – €4.00 net (excluding VAT)

For file: RJ4JP_x-carriage_complete_0.2mm_PETG_MK3S_4h7m.gcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €3.64 excluding VAT (range midpoint).

Weight reported by the author
38 g
Print time reported by the author
4.12 hr
Source material
PET
Estimate material
PETG
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

X-carriage and X-carriage-back for Prusa MK3S and MK3S+ made to fit Igus RJ4JP-01-08

Rating
5 / 5
Likes
20
Downloads
118
Makes
1
Views
1,399
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution

I found a model with modifications to the original Prusa MK3 X-carriage and X-carriage-back to make Igus Drylin RJ4JP-01-08 bearings fit better, but couldn't find any version for the MK3S or MK3S+ carriages. I compared the .scad files from the file I'm remixing to the original MK3 files with the same rev. number, and made the needed changes to the current R7 parts for the MK3S/+. I also changed the rev. number printed on the parts to R7i, to distinguish them from normal R7 parts, and included the .scad files in case anyone needs to make minor changes for their specific setup.

Print with the same settings used for printing normal MK3S/+ parts, i.e. PETG with default 0.2mm settings.

NOTE: I had to modify the firmware to increase the homing currents to {15, 12, 20, 18} to get the printer to pass the belt test. This is still lower than the actual print currents so I don't see why this would cause any issues.

Tags